Difference between revisions of "SenseStage"
From Lahaag - Project wiki
Jump to navigationJump to search| Line 1: | Line 1: | ||
| − | |||
| + | Step 1 : configure Xbee modules if not configured yet for SenseStage, | ||
| − | + | http://sensestage.hexagram.ca/xbee-choice-andconfiguration | |
| + | http://docs.sensestage.eu/change-to-using-the-api-mode-of-the-xbees | ||
| + | Remember to set the API mode to ATAP 2 or in XCTU, 2 API ENABLE W/PPP | ||
| + | Step 2 : change firmware if needed on minibee to fit your sensor | ||
| − | + | Step 3 : Install pydon | |
| + | |||
| + | |||
| + | |||
minibee | minibee | ||
pydon software | pydon software | ||
Revision as of 08:50, 13 October 2013
Step 1 : configure Xbee modules if not configured yet for SenseStage,
http://sensestage.hexagram.ca/xbee-choice-andconfiguration http://docs.sensestage.eu/change-to-using-the-api-mode-of-the-xbees Remember to set the API mode to ATAP 2 or in XCTU, 2 API ENABLE W/PPP
Step 2 : change firmware if needed on minibee to fit your sensor
Step 3 : Install pydon
minibee pydon software sensestagedatanetwork
Step 1 : Configuring Xbee modules http://sensestage.hexagram.ca/xbee-choice-andconfiguration
